Interior/Boot PCB SMD Festoon Dome Light Panel (xenon white)

Good ole' universal fits all

One size fits all (but not a zed)

 

...OOOPS !!!! ... i keep intending to install mine but get sidetracked ... think i may now hold off until some clarification from Ivan, the seller .... ????

.. Ivan, any thoughts on what has happened here ...????

 

Basically, the 'smallest' bulb that comes supplied with the kit is 1 size larger than factory bulbs. I'm not sure what size they are, i haven't measured them, but it's a 'bit' bigger. Mine still fitted without any problems whatsoever, I Just needed to pry the 2 terminals apart just a little bit to get it to fit and no worries.
I suppose depending on the condition of your light fitting/terminals may vary, but mine is ok. No fuses blown, nothing bent/broken, mine fits fine. That's about all that i can comment on.

 

Can you show a pic of the fitting you used and the old bulb?

 

Old bulb thrown by now, i'll see if i can take a photo of how it fits with new panel tonight.

 

need pics before i get a set of these lights!!

some1 post pics..

 

HI:
is there any chance you can hardwire it into the housing by using there other adapter, like the T10 adapter, just pull it out and tap the wire?

i checked all mine, they all 3mm bigger.

usually by just bend the pin a little bit will fit, and i try to contact the supplier see if they could have a smaller adapter that fit the "z"

sorry about that

 

is that still keep blew the fuse now?

 

the only solution i think of now are, get the T10 base adapter, and pull both wire out form the base, than at the end of the 2 wire should be 2 hard metal pin,

with your current housing, there should be 2 little hole on each side, so hook the two wire into the hole, that should get it work,

and i will try to get a one size smaller adapter and resend to you guys.

 

... i think that i will be waiting for the replacement adaptor ...

.. please keep us updated on progress, ivan ...

 

Me too

 

Sorry if I'm buying a product this simple I don't expect to have to modify it to make it work. I thought I might try it in my fiances car and it won't fit with that either, has the same size as the zed. Also I can't get the lights to come on even when touching the terminals to the connector (and yes I have tried reversing the polarity).

I do not recomend this product, good thing it wasn't expensive.

 

generally light globes should fit the car your selling them to fit into...

 

HI:
the smaller adapter has arrived, and who needs them please Pm me and ill send them out to you

BR
Ivan

 

HI:
i am happy to give you full refund if you can send it back to me

BR
Ivan

 

PM heading off, shortly ... thanks, ivan ....

 

Turns out it blew the fuse, don't know why?

I replaced the fuse and put the old bulb in, I havn't re-tried the LED's since. I will try again and get back to you. If it works I'll PM for a smaller adapter.
Thanks.

 

CAN WE GET SOME PIC PLEASE FELLAS

 

IVAN .....

PM sent on 5 jan regarding replacement adaptor ....

.. appreciate early response ....

 

FITTED PICS HERE PEOPLES!

I've put the 12LED PCB in my main cabin interior. Fits perfect and lights up beautifully! highly recommended. (photos don't do it justice as my camera takes poor night shots)




... and i also bought the 6LED Panel for the boot light. Obviously not as bright as the 12LED but this is the biggest size that you'll be able to fit inside the light covers.