Hi All I recently found a great hole in the firewall to use for my three autometer gauges, only problrem is that its for the clutch and I'm about to try the auto to 5 spd conversion. So, where do people usually put hoses and wires through into the engine bay please? Its so bloody crowded in there I haven't a clue cheers Geoff
Thanks for that, I might just grab the drill and go for it! Thanks also Rob I'll check ou the pass side too as an option. cheers Geoff
Be very very careful Geoff when drilling anywhere on the zed. Take it from me there are wires everywhere and I have found em too with my drill bit. Could try removing the RH front guard and running the wires through the main wiring grommet located behind it works well and is very factory and out of the way.
M8, It's all in the tech section. Best, easiest,simplest place is where the bonnet release goes through the firewall, Pull the grommet aside and poke through carefully with a fine screwdriver. Tape your wires to a strong bit of wire ( coat hanger) and work through. Only takes minutes