https://drive.google.com/file/d/15Pn1v7RM-JclK1rIif2Xiy3rdnDZnr3V/view?usp=drivesdk https://drive.google.com/file/d/1yslpVhY46VC_1J2ErpDGKV7mZJbZy1Rm/view?usp=drivesdk Hi all Any thoughts on fixing this myself, I tried glue tabs and a puller, they just broke as the steel is thicker than the rest of the body. I made a steel tab but it still won't pull it out where the first bend is.
I have used a “weld on” dint puller like the one below to remove dints from sills and pillars in the past; https://m.ebay.com.au/itm/Stud-Weld...Nails-Slide-Hammer-Electric-HOT-/332147986219
Hi m8 I work at a panel shop capital Smart u need to weld a bit of flat steel to it drill a hole in the flat bit of steel put a d shackle on use a (big) slide hammer u can get at yore local auto paint suppliers one that supplies panel shops not autobarn or repco and pull it out while tapping the top level repeat where u need to fill and paint done a lot my self this way works every time I’m assuming u have done this before?
Hey i have seen this used before on YouTube, didn't realise how cheap it is. Might give it a go. Thank you
Hi Bret when i get my mig welder i will give it a go. If its successful i will put some pics up. Thanks
