Hey guys, I need some advice on removing/fixing the headlight on my TT. It seems the front drivers side projector lamp is not "aligned" properly and is putting out bugger all light (especially since the globe blew last night). I cannot get the globe out to change it as it seems the projector housing in the assemably has moved and i can't undo the clip holding in the globe. My First question is probably is this fixable or will i need a new Headlight? and if it is fixable how do i go about doing it?
If you think that is the case (which I doubt or you would have considerable play in the globe end or connectors) then remove the entire headlight assembly and see if the helps. While your at it do a hid conversion if you want, clean the dust off the projector lens to as after time they build up a film of dust , Plus stock globes put out sweet f all light
i was gunna call u about it but i got the wrong number in my phone for ya.. I got it sorted now anyways. Turns out the lens was aimed at the moon so i brought it back down and i could get the H3C globe out (stupid size = bugger all replacements) so im putting new globes in now... lol
I'm unsure what you mean by this comment, as the H3C globe is exactly the same size as the H3 that the Australian delivered Z32 uses. The ONLY difference is that the H3C "earths" through a second 'spade' connector on the rear of the globe(unlike the H3 which "earths" through the 'collar' of the globe and therefore has only one 'spade' connector).
