We thought we would share this with everyone on here, cause we know firsthand how much easier they make working on the zed The HAPP R1 is designed for customers who have low ground clearance vehicles that need to raise the car slightly to get a jack or auto hoist arm underneath. Ideal for sports, competition, show and racing cars owners. Key features of the R1 are: The gentle 8.5 degree slope allows cars with low front spoilers (bars) to edge the car onto the ramp, the wheel raises up to to its lift height and then drops slightly into its holding positon. The dimensions shown in the diagram illustrate the precision calculations of this ramp that allow the car to move up and be held in the lift position. The ramps are made from plastic moulds with honeycombe design to promote strength which allows the ramp to support up to 3T in capacity. The honeycombe design also allows the ramp to be fixed to flooring if required. The plastic construction minimises the chance of damage to a vehicle should the ramp contact the vehicle. The specfications of the R1 are: Length : 700mm Width: 200mm Max lift height: 63mm Ramp angle: 8.5 degrees Length from ramp to hump: 460mm Height at hump: 69mm Height at end stop: 79mm Construction: moulded plastic Max weight 3000Kg $129 delivered to your door if you are interested in a set. Please email me at maree@happ.com.au for our bank details, or send me a pm on here. If you would like to talk to us about any of our other products, you can contact Gavan on 0439838477 or myself on 0439833497 or take a look at our website - www.happ.com.au www.happ.com.au