Removing exhaust....

Discussion in 'Technical' started by JEDI-77, Jun 16, 2016.

  1. JEDI-77

    JEDI-77 Jedi Master

    Messages:
    5,963
    Likes Received:
    19
    Trophy Points:
    38
    It seems that after 15 years of being on this forum, I still have some newbie questions left in me. Ok, so here goes;

    I'm planning to remove my current exhaust and temporarily install my stock TT exhaust back on. I'm assuming that removing the exhaust involves unbolting the 3 bolts at each dump pipe and unhooking all the hangers. Is that it? Or should I expect something more challenging? Also, was planning to do this on jack stands or should I seek a mate with a hoist?

    Cheers
     
    JEDI-77, Jun 16, 2016
    #1
  2. Madcow

    Madcow Active Member

    Messages:
    1,684
    Likes Received:
    17
    Trophy Points:
    38


    Thats it! If you have cat temp sensors make sure you undo them.
     
    Madcow, Jun 16, 2016
    #2
  3. Fists

    Fists Well-Known Member

    Messages:
    1,453
    Likes Received:
    35
    Trophy Points:
    48
    Unless you've got a system with American dump pipes, in which case you'll need to swap the dumps as well.
     
    Fists, Jun 16, 2016
    #3
  4. geron

    geron National Petroleum Equipm

    Messages:
    608
    Likes Received:
    56
    Trophy Points:
    28
    On the hoist it's so much easier with air tools :)
     
    geron, Jun 16, 2016
    #4

Share This Page