What have you done to your Zed today?

Looks good alex.

:thumbup:

 

2nded. They look great McA***Lovin

Cant wait to see some better pics of them

 

Today. I fit the Aircon back into my car. Rebuilt compressor for R134a, new seals and reciever drier. Getting it gassed tomorrow.
Also replaced my leaky KOYO radiator with a new one.
While I had everything apart I put the trumpets back on my GFB Hybrid BOVs. Back to semi Atmo venting. VOOOOSHHH :zlove:

 

Thanks Alan, you're so anal about these things.

Going to change the rotors sometime or at least paint the stock rotor hubs black.

 

You had better wipe that Tyre shine off!

 

There Lookin Purrrtty Alex.
rim/tire Sizes and offsets?

 

Advan RS-D 18x10+35 & 18x9+35 tyres Yokohama Advan sport 265x35 rear 235x40 front.

 

Fitted S2 climate control pod and amplifier to the 2+2TT. PITA getting to the amp with the internal clutch booster.
Pulled the 300km/hr Mines speedo and boost gauge cluster out and replaced with Impul 300km/hr and OEM boost gauge.

Went to pick up the NA from the painters, only to find the windscreen, doors, hatch and hatch glass pulled. Another 3 weeks till its ready, and another $20

 

Fitted my new dials today
I have to set the speedo needle back to 0 properly but they look sweet

 

"Cleared" my aus spec and jap spec indicators.

 

Changed the HKS Air filter to a pod filter, fitted Silicon Radiator hose, and most important,
Packed it for ZedFest to be ready in the morning.

 

Ezzup those dials look GREAT ! what are they where you get them from ?

 

Put in a new CTS and then pulled my hair out looking for another roll of solder to fix this PTU plug.

Then I gave up and went to Zedfest without it

 

Soldered in a s2 ptu, ouch my back.

 

I always seem to have the tendons in my knees sore from leaning over the car when I do PTU's. Go figure

 

I tried to cheat with a bar stool, maybe that's why. Runs well considering I had to use electrical tape, the shrink wrap I had laying around's diameter was too large.

 

better than ure back ;/

and this is what i did a few days ago.

 

I have the exact same gauge overlays sitting in a box to install got them about 6 months ago ... was it very hard, how long did it take? might send you a PM to ask for tips

 

they're available on yahoo auctions. Do a search under "300zx". Currently only speedos with MPH and KMPH, but can usually choose from either

Made Another payment for paint. Went to pick up, only to find additional work- doors removed, windscreen out and hatch off. Engine was too hard for them to get out

...... Should be ready when i fly home again end of this month.

 

Should have pulled out some weeds, but gave the Z a 'quick clean' instead....



Used the glue remover to finally get around to removing some stickers and original Japanese registration - on there since 2005, but was starting to fade and peel.....