Just purchased one of Karl TTS units and thought I would give it a bit of a wrap. I am using it as a launch control (more of a burnout control at the moment) which is triggered by the sensor on the clutch which runs through a relay. Anyway when you put your foot on the clutch it is rev limited to 6000rpm then goes back to the normal tune with the clutch out. It works great however I have a fat lazy foot and sometimes I hit the clutch before I take my foot off the throttle and cause it to hit the limiter and flood. Does anyone have any other great ideas on uses for one of these: I have seen it used for: a launch control an economy tune a nitrous tune
Valet mode - for when (if) you ever leave your Zed in someone elses care. RPM & speed cut for Granny (or Fate)?
Hi Jason... Can i ask why you have your launch control tune set at 6,000rpm? Because the stock tune has the rev limiter set at around 6,400 off memory, so I can't see any benefits here apart from just sitting doing burnouts instead of properly launching.
Probably right Chris Mines around that, but i thought that my tune had the limiter raised from stock. oh well, i could always rip my tune and check it out - or just crack a beer instead. Hmm, might go with the latter.
