Hi guys I wanted to remove my rear, passenger side fender. I need to remove this panel to hit out a dent. How should i try and do this? from the inside? The outside? I saw that i might only have to pull it out enough to get a rubber mallet in there, as It appears to be one long panel that follows around to the drivers door? Any help would be great! thanks.
Rear quarter panels are welded on.....>> Makes them a little tricky to remove. Depending on where the dent is you might be able to gain access to it from the inside.
The normal way to pull dents out where you cant get to the back IS to get a stud welder, and spot weld studs over the dented in section and pull them out. You could do it with a mig and some steel. Welding the steel in quite a few spots and pulling the dent. Dont ever drill holes in a dent to pull it.
