Rear Seatbelts Help

Hi fellow Zedders,

Need a bit of a hand in the last stage of transferring my Rego from QLD to NSW.

my last hurdle is rear seatbelts. My local seatbelt/restraints bloke has never done a zed before and needs to see the mounting points for the Rear seatbelts.

If anyone with a 2+2 with over shoulder belts installed could please throw up some pictures of how where the mounting points are meant to be it would be much appreciated.

Thanks

 

did this zed not have 3 point seat belts when it was complied?

i know earlier 2+2s all had 2 point belts from factory and nearly all of them when imported got 3 point during compliancing.

this is all i can find without taking new photos, the top mounting point is just above the rear hatch strut. if you remove the trim there should be a mounting hole already there and it will need a thread welded in. also if you remove the trims there is a big gap in there for the belt recoil mechanism.

 

Thanks very much Mike, Is this how the Aus Spec ones look?

 

I wouldn't know... mine is Jspec but I'm pretty certain it's done identically to the way factory 3 point came on later models.

 

Alrighty Thanks mike, Anyone have photos of Aus spec rear just to confirm?