Ok, ran into some trouble fitting my new tune agent dumps and test pipes.. I previously had a customer Trust exhaust system from the dumps back, so I figured they would have retained the same orientation of the flanges... no.. *Sigh* So basically everything bolts up just the flanges need to be rotated. Now this is relatively easy to do but at this point im lazy and want a new exhaust. I'd like to very much go stainless all the way (currently its mild steel) and go out to some nice twin 3" tipped exhausts. Was looking at a few of the N*Power mufflers which would fit exactly what im looking for. My only question is are they any good. Ive searched and found a few people have fit them but not alot of followup on what ended up happening, do they still have them, how did they go in the long run? Etc. Aside from that suggestions on where to go to get the remaining piping welded and bent to fit. Eg the only work that needs to be done is the new piping bent into shape (the current system has some baaaad 90degree bends) and welded up. So for such reasonably simple work, where can I go that wont rip me off. And I will also need 2 new resonators. Btw if anyone wants the old system make an offer. Its if I remember right a twin 3" from the dumps back. The front pipes are dented as are the first set of resonators (it didnt have any cats just 2 sets of resonators on each side) otherwise it worked fine and was pretty good, but for the moment im nowhere near the power level that would require 3".
