Those of you who know my project know I am out of control with the things I am doing to the car. As such the standard engine wiring loom has change so much it will be able to use the previous plug in LINK ECU. This is a fully programmable ECU which I will supply with programs, and will fit if in the Melbourne area. Yes it is expensive for a second hand ECU, but if you know your ECUs you will not that this is direct competition to the MOTEC. Also, unlike other components this never wears out do to, age, over use, racing, or poor maintenance. Some of the features include: 440 Fuel Zones (with 16 calculated zones between each zone) 440 Ignition Zones (with 16 calculated zones between each zone) Cold start adjust Acceleration Adjust Boost control (no need for a separate boost controller or bleed valve) AC compensation Idle control Fan control RPM limit setting Soft and hard RPM limits MAP vs AFM control Knock sensor input (including adjusting when it will respond by retarding timing by 6degrees) And it goes on. I have the manual, and separate hand controlled which is very self explanatory, and will enable you to tune it your self with a little patience and care. I'll also include the connections to allow you to connect it to you laptop so that you can data log. Happy to post for free for those out of state.