Engine bay loom burning

Discussion in 'Technical' started by ACTZX, Aug 19, 2007.

Page 2 of 2
  1. ACTZX

    ACTZX New Member

    Thanks AndyMac

    Just went and checked that I had tightened the bolt enough. Yes it's tight. Still didn't start.
     
    ACTZX, Aug 26, 2007
    #21
  2. ACTZX

    ACTZX New Member

    The Z is alive

    Problem? The pins of the lower connector on the PTU were covered with corrosion. New pins were not contacting. Cleaned them and the Z sprang to life.

    Life begins again!
     
    ACTZX, Aug 27, 2007
    #22
  3. black baz

    black baz black 'n blue Bazemy

    whoopee, charles ...welcome back to zedland ....!!!

    ......:zlove: :zlove:



     
    black baz, Aug 27, 2007
    #23
Page 2 of 2

Share This Page