Hey all, My TT shell has been sold, so i no longer have the use for the following parts, nearly everything is there to create a reasonably fresh complete TT engine (just add turbos of choice) as well as extras. Im looking for $2000 for everything listed in this post or will part out as described below (please note preference will be given to persons looking at taking the lot, but will take shotguns on parts). The TT heads, purchased as reconditioned and have new valve guides, stem seals, then i had reflex engineering regrind cams, and pressure test (have receipts). $600 pair The TT block was running with no bearing noise, i pulled the crank out to check the bearings and considering the heads are vitrually brand new i would suggest that the bearings and rings be replaced for peace of mind. $400 $ 5 each ? L & R engine mount brackets $10 ? hard fuel lines $10 each ? 2 x Balance pipe $10 each ? 2 x turbo to exhaust manifold gasket $10 each ? 2 x 4 bolt dump pipe gasket $15 each ? 2 x pair of lower manifold gaskets (one pair round at top, other pair square) $15 ? pair of rubber cam cover seals $15 ? Nissan oil pump gasket (still in bag) $10 each ? cam covers $10 ? thermostat housing $10 ? TT Alternator bracket $10 ? TT HICAS ps bracket $10 ? rear wiper motor $10 ? washer res $10 ? fuel rail with 5 injectors $20 each ? L & R turbo exhaust manifold $20 ? pair of TT oxy sensors $20 ? ausspec Indicators $20 each ? 2 x Lower intake manifold $30 ? Intake manifold w throttle bodies $30 ? 300zx space saver $30 ? Standard Zed wheel $30 ? TT TPS $50 ? Black Bonnet (few scratches, need cut n polish or respray) $50 - Almost new water pump $50 ? TT oil pump $50 ? TT CAS $50 ? Pair of TT oxy sensors $50 ? clutch master cylinder $50 each ? 2 x starter motors $60 ? 6 x TT working coil packs $100 ? Wheels x2, good tread, no leaks (only have 2) $160 ? Powder coated intake manifold & water pipes (comes with throttle boddies, idle valve, gaskets for idle and throttle $230 ? Pair of cometic metal head gaskets, 045? 90mm (brand new in pack) $400 ? NA Exeddy 5 puck, brass button clutch & flywheel (used on my TT and didn?t slip even at 200rkw, almost brand new) I will put up photos tonight of the heads and block.
