Are any other models wheel studs compatible with the rear hubs on a 90 NA? In a bit of a jam and can't find anyone who stocks them.
This should help you a little: M12-1.25 thread size; 12.83 mm knurl diameter; 41.5 mm length; 14 mm shoulder length; OE numbers 40222-15000, 40222-15C00, 40222-4P000, 40222-A0800, 43222 91P00, 43222-06R00, 43222-06R01, 43222-06R61, 43222-35F00, 43222-50J00, 43222-50J06, 43222-8B400, 43222-N3200, and 43222-W1200
Im in dubbo, tried Repco, AutObarn and Super Cheap but none had any in stock. No other places open here on a Sunday... They said they can order some in but I really need one today as im supposed to be heading to Qld tomorrow. I can just get a nut on the one in there, it's snapped off shorter than the rest. Might be ok till I get there
Im in dubbo, tried Repco, AutObarn and Super Cheap but none had any in stock. No other places open here on a Sunday... They said they can order some in but I really need one today as im supposed to be heading to Qld tomorrow. I can just get a nut on the one in there, it's snapped off shorter than the rest. Might be ok till I get there
Try BobJane or other tyre dealer as they are snapping them all the time. Arn't ford the same stud, i'm not sure.
Nooooo no no no no :rofl: Ford are dirty old half inch rubbish, not sure about the knurl size but doubt that would fit anyway. Tyre dealers is a good call though
Went through the whole lot at Autobarn and found one that fit... Sort of. The splines were about .5mm bigger so it took some persuading. All in now though. Another question, how the feck does the hub come off? I went and borrowed the huge sockets and drI've to get the nut off and couldn't budge it
