Clutch Slave cylinder pushrod

Discussion in 'Technical' started by B-Line, Jun 15, 2014.

  1. B-Line

    B-Line Older junior member

    Would anybody be able to tell me what the correct lenght might be?, mine has been cut for some strange reason, I am going to get one made and need to know what the factory length is

    Thanks
     
    B-Line, Jun 15, 2014
    #1
  2. WazTTed

    WazTTed Grease Monkey

    You can use a bolt grind the end off :) measure the maximum travel of the slave and make bolt long enough to push all the way in
     
    WazTTed, Jun 15, 2014
    #2
  3. B-Line

    B-Line Older junior member

    Thanks Wazz
     
    B-Line, Jun 15, 2014
    #3

Share This Page