Found little information on this part so far. Its the thin plastic strip ether side of the windshield to hold in the molding. Whats the part number and where can I get a set from? Mine fell apart when removing... I havnt been able to find any on websites, maybe something have to order? Cheers guys
Nissan part numbers are: Right: 72728-30P00 Left: 72729-30P00 About $20 EACH FROM CZP in the states or probably about $60 each from Nissan Australia, by all means call local Nissan and post back price for a laugh. It is just a plastic channel that the trim mount tabs can stick in, it is usually double sided taped to the side of the A pillar, I cleaned all the old tape and goo off the pillar and the plastic bit, bastard of a job with the windscreen out and used "Scotch Mounting Tape" a double sided 1mm thick foam tape, and trimmed width to suit. With the screen in I do not think you are going to have much success unless you are prepared to get a dremell tool in there and gouge the old adhesive out and take paint off, maybe a bead of silicon and a good clean of the plastic strip and make sure it presses hard to the pillar as it sets the position of the trim. Prove me wrong, but what ever double sided tape Nissan uses its bloody tuff stuff, I tried all manor of solvents and chemicals to get it of, in the end hours of picking and scrubing.
Thanks heaps brisz I guess you havnt seen my build thread then It has no windows at the moment. the only glass is has is the rear view mirror haha. Thanks mate
LOL no worries, i try to stay out of the builds area, it gives me stupid ideas. The Scotch tape was a tiny bit too fat and made the trim sit a tiny bit off, if you can find some similar double sided foam tape thats a lil bit thiner it would be ideal but OK with the Scotch.
