Apexi Power FC & hand controller,wiring harness,sard 800cc inj,

Apexi Power FC with hand controller, 6 X sard 800cc injectors & collars with wiring harness to suit, , E Boost (for variable cam timing), and twin air flow meters.

The Power FC is worth around $1900, the injectors were around $800 +sard collars, E Boost is worth $800, and air flow meters are worth $350 each.

There is a fair bit of info on the forum regarding the Apexi Power FC, it is the R33 unit modified by UAS.
here is one link http://http://www.aus300zx.com/forum/showthread.php?t=259873&page=2&highlight=Apexi+power+FC
**not to be confused with a Apexi Super AFC**

Need to sell the whole lot as a package as the wiring harness has been modified to suit all of the above bits ie Sard Injector plugs on the wiring.

If you have Sard Injectors already, we can sell the injectors separately.

The computer has been tuned to suit the setup with the bigger GT28R turbos(also available, see note below), so it is ready to go. Many hours have been spent tuning it, but it would need to be touched up to suit the new combo.

Looking for $3800 for the whole lot.

also in sep add...
2 x Garrett GT28R turbo?s with smaller sized actuators (12 or 14 lb springs from memory) and split dump pipes (floor needs slight massaging to fit them so they sit up really high) $2000

 

A little more detail ..

E-Boost is E-Boost 2 model.

The wiring harness was wired by UAS to suit the Apexi Power FC with Hand Controller, E-Boost2, and twin air flow meters. It is the complete engine bay harness for the Apexi Power FC.

Includes 6 X Sard 800cc injectors and the Sard Collars , so the injector plugs on the harness are the Sard ones.

They are the genuine Sard collars (not the ones Tecky was doing) so there is no 'modifying' to be done to get them to fit, they drop straight in.The Sard collars fit without grinding clearance in the plenum.

The air flow meters have 3? silicon joiners and air filter adaptors, so they are ready for a pod filter to be fitted.

This means that each throttle body draws air through a separate air flow meter and air filter and the harness and computer have been wired this way.

We supplied the Computer and air flow meters and UAS charged us $2800 to wire the computer, supply and wire the e-boost 2, and check the air flow meters.

After that, the air flow meters were reconditioned which cost another $400

(The computer with hand controller is worth $1900 new (can?t get them anymore), the e-boost 2 cost $800 new, the injectors were $850 new and the collars were another $200.)

The Apexi Power FC computer is very easy to tune and most good tuning shops are ableto do this.

The air flow meters are worth $400 each if you sell them separately and these have been reco?d so are in new condition.

Asking $3800.00 for everything.