I bought a clutch fan today from repco Itsfor a Nissan Patrol Carb model (4.2L 91/98 model GQ)The clutch fan is a dayco part number 115072. I am...
and how much it will cost? (In Victoria)
map, give me the dummy version:LOL:
Polished radiator hard pipes i also did the cas mount but you can't see it in this pic. If a bit more time was available, it would have been a...
it? I told him it could be the fan belts, but he insists it's the clutch fan.
durabilty can i expect, like will it look good for two weeks and then start to crack and fade? My timing covers are getting painted(silver, two...
tensioner, water pump the whole lot! Also polished the CAS mount and water hard pipes for a bit of bling. Gave myself a bit off a fright though,...
and everything was going fine until my brother decided to help. But when it came to cracking open the crankshaft bolt, my brother insisted on...
that hold the idler pulleys? i will be removing the old ones and putting in new ones. Also while we are on the subject, is there any other place...
belt? I did a search on the subject but couldn't find anything. The reason i ask is that i have a Dayco timing belt. This is what it says on the...
it says that you have to disconnect the exhaust from where it joins on to the H pipe, to get the swaybar out. But i found it impossible to undo...
similar fashion to the zed. The endlink mounting hole for the zed is horizontal is the r32 the same or is the rear of the r32 mounted like the...
I am not going to do it myself, but i am just curious as to how its done.
10psi! And when i give it a bit, at about 5000rpm it starts to shudder. What the fluck is going on here?
Is there a special tool for this, because today i wanted to change my diff oil but couldn't get the plugs off. The only thing that would fit in...
If you remove your AIV and PRVR you will be eliminating 4.5m of vacuum line, some of it hidden.
can i remove to simplify my engine bay. When removing the AIV is it better to remove the solenoid or just block it off. Also what is the other...
suffice? While were on the subject what else do i need to get that power? Current mods Pod Down pipes(2.3inch)going on this saturday Chip(...
If anyone has please post a pic. I am thinking of making one to change the rubber bushes.
a result of it. I am seriously considering the idea but a bit scared that it might cause premature wear on the bores.
Separate names with a comma.
