Here's another tip for getting stuck O2 sensors unstuck - this is the fastest way I've found: Get a can of Air Duster spray (canned compressed...
Acetone is also great for cleaning off the gunk on that lower plenum. Wear gloves and take great care not to get any on other painted surfaces...
A local guy near me does Z repairs all the time. He says that just changing out the connectors is just as good as replacing the harness. Idea...
Examine the upper shifter dust boot while you have everything all apart. If ripped or torn it's a good time to replace that too (while...
How long is it going to be? Things to do if stored for a few years... - Add fuel stablizer to last tank of gas well before storage to let...
I bought aftermarket mufflers here in the US (from eBay) for my 2+2. Perfect fit for the factory ones (painted black too) - bolted right in, was...
For illuminating the wiper control icon at the bottom of the pod. The bulb for that is buried inside of the control assembly. I used some...
Yes, did confirm the sizes were right. Bleeder valves used for the clutch system are the same size as the ones used for the brakes. But I...
I think the main issue is that not all of them are manufactured to high quality standards. Small manufacturing imperfections causes them not to...
Seems like when they leak - more drips and drabs than a lot. Just enough to mess up finished surfaces... Yes - even better idea to use them...
Just a note of caution with the SB's -- after they're installed be very sure to inspect them for a few days. Sometimes one will leak causing...
Manual clutch bleeding... Several things work well.... - First thing I do is remove the slave bleed valve and just let the fluid drip. Wait...
FYI -- I just painted my TB's and didn't take them apart. Was pretty easy to mask up the body with tape and spray the springs and lever with...
Well probably doesn't matter -- as I posted earlier, visual inspection doesn't do it all (but if you can rotate the belt, will let you see if any...
One other tip -- very likely the plastic cowling just above the battery will be pitted a bit. Pitting is caused by battery gases. Before...
Separate names with a comma.
