There was a dry solder in mine which caused it to cut out now and then and got progressively worse. We opened it up and resoldered the connections...
Fuel smell could be because the rubber fuel hoses shrink in the cooler weather and the hose clamps need tightening. have a good look around and...
Could be your PTU. Is it a series 1 PTU? Mine did that and that was the cause. Its a common problem.
Hi Baz. how are you going? I have been looking at a certain NA manual on the central coast area, but my better half would kill me. I would be back...
I found my zed turned into corners better without the brace. It was most noticeable in tight chicanes....(roundabouts) haha
Kittens no. 3 buffing compound will fix up most of that :eek:
Hey Baz. You never know. There is a lot I don't miss about the z32 - two of everything to replace/upgrade, annoying rattles to chase, leaking...
Whoa!! Now I definately want it back. No, just kidding. I would probably look for a nice manual NA. Fast enough with exceptional handling. I miss...
Hi guys and girls. Its been a while since I left the zedding community and could be time to make a comeback. Just wondering if the buyer of my...
I replaced my fan clutch assembly on my former zed when the temps sat at around 5 - 10 degrees above normal operating temperature. Once installed...
Prices are still dropping:(. K-zed and Keiren have dropped their excellent zeds well below what they should be able to get. Also I've seen a...
Sold pending payment. This doesn't mean I won't consider getting another zed. It does mean the pressure is off :D.
Final price drop to $100 + postage Remember this is a genuine Stillen urethane nose panel. If it doesn't sell at this bargain price I will...
Zed4life is our local guru on this. Mark sells and installs ZIDs (zed immobilisation devise) too. PM him for good advice.
Separate names with a comma.