If you could spend 1 grand on mods

Discussion in 'Non Technical' started by riden21, Apr 29, 2013.

  1. riden21

    riden21 New Member

    Messages:
    398
    Likes Received:
    0
    Trophy Points:
    0
    Okay so imagine you've taken care of your Z, exhaust done,suspensions and brakes sorted,she also looks like you would want her to, you are allowed to spend 1000 bucks on engine mods, what would you buy?

    it can be new or secondhand, it doesnt matter
     
  2. bRACKET

    bRACKET Do Right Dean

    Messages:
    3,037
    Likes Received:
    0
    Trophy Points:
    36
    Intercooler(s), injectors & boost controller.

    All parts will give you more power and safety, engine wise.
     
  3. MikeZ32

    MikeZ32 das Über member

    Messages:
    2,806
    Likes Received:
    115
    Trophy Points:
    63
    get it tuned for $1000 or be boring sensible and chuck it in the bank. i would do the latter.

    there's no point putting intercoolers and bigger injectors in if you don't tune it at the same time.

    $1000 will not get you both so the best option is just put better coolers on, crank up a boost a bit within safely and bank the change.
     
  4. ezzupturbo

    ezzupturbo JDMAutomotive

    Messages:
    2,055
    Likes Received:
    45
    Trophy Points:
    48
    japteks, jamies sards and nistune
     
  5. ZYTRAM

    ZYTRAM Formerly known as martini_Z

    Messages:
    1,523
    Likes Received:
    15
    Trophy Points:
    38
  6. ABZ300

    ABZ300 G

    Messages:
    3,273
    Likes Received:
    1
    Trophy Points:
    36
    Spend it on your mrs & get some instead of pissing her off by spending soo muh on the z :p

    Abraham
     
  7. riden21

    riden21 New Member

    Messages:
    398
    Likes Received:
    0
    Trophy Points:
    0
    thats nice!!! injectors i'm getting jamies one, but instead of the chip i'd rather go with the nistune or similar, and would the FMIC fit the stock front bumper?
     
  8. bRACKET

    bRACKET Do Right Dean

    Messages:
    3,037
    Likes Received:
    0
    Trophy Points:
    36
    Might need to trim the bumper a bit, nothing major.
     
  9. rob260

    rob260 Administrator Staff Member

    Messages:
    13,706
    Likes Received:
    689
    Trophy Points:
    113
    Location:
    Sydney (North)
    Why are you upgrading injectors and ECU? Have you fit aftermarket turbos?
     
  10. bRACKET

    bRACKET Do Right Dean

    Messages:
    3,037
    Likes Received:
    0
    Trophy Points:
    36
    Safety can't hurt right? With a stock setup isn't it injectors and coolers that start giving out at higher boost?
     
  11. rob260

    rob260 Administrator Staff Member

    Messages:
    13,706
    Likes Received:
    689
    Trophy Points:
    113
    Location:
    Sydney (North)
    Not sure what PSI the injectors run out at?

    Stock intercoolers are struggling above 14psi (intake temps getting too hot). Not sure about injectors...?

    Fitting new injectors and fitting and tuning aftermarket management seems to be a massive pain in the arse if you're not going to see any benefit from it.
     
  12. riden21

    riden21 New Member

    Messages:
    398
    Likes Received:
    0
    Trophy Points:
    0
    i heard injectors are bad past 14 too
     
  13. rob260

    rob260 Administrator Staff Member

    Messages:
    13,706
    Likes Received:
    689
    Trophy Points:
    113
    Location:
    Sydney (North)
    How hard you planning to push those stock turbos?

    By all means keep spending money on parts, it keeps the forum economy running, but have you thought this stuff through?
     
  14. ProckyZ89

    ProckyZ89 Senior Member

    Messages:
    3,055
    Likes Received:
    46
    Trophy Points:
    48
    Location:
    Goulburn NSW
    Hmm , stock turbos past 16psi won't do anything really .. Plus it's a accident waiting to happen,

    Stock injectors will handle that fine.

    I had stock injectors on 240rwkw.
    I mean each to their own, but it's not really a necessity
     
  15. bRACKET

    bRACKET Do Right Dean

    Messages:
    3,037
    Likes Received:
    0
    Trophy Points:
    36
    I dunno man, coolers and injectors with a tune to suit would be pretty close to 1k, pretty good upgrade over stock if you boost it to 16psi I'd say? Plus you then have the gear to go higher if you want.

    I'm just going by what I've read, never played with a stock TT, but if it was me I'd be doing those things.
     
  16. rob260

    rob260 Administrator Staff Member

    Messages:
    13,706
    Likes Received:
    689
    Trophy Points:
    113
    Location:
    Sydney (North)
    Well going by 1cc/rwhp rule of thumb stock injectors should max out around 276rwkw.

    Most TT's with stock turbos are pushing around 215-230rwkw with bolt on mods, which the stock injectors should be able to handle no probs.

    I understand what you're saying, but I do think that upgrading injectors and ECU on an otherwise stock car is pissing money down the drain.
     
  17. Romonski

    Romonski And Justice For All

    Messages:
    2,219
    Likes Received:
    9
    Trophy Points:
    38
    i agree. But it wont hurt :p
     
  18. rob260

    rob260 Administrator Staff Member

    Messages:
    13,706
    Likes Received:
    689
    Trophy Points:
    113
    Location:
    Sydney (North)
    Turbosmart boost tee $100
    Apexi Power Intake kit $120
    Godspeed Side Mounts $250
    N power 2.5" catback exhaust $550
     
  19. rob260

    rob260 Administrator Staff Member

    Messages:
    13,706
    Likes Received:
    689
    Trophy Points:
    113
    Location:
    Sydney (North)
    Why would you go to the trouble of a twin intake system on a car with stock turbos? Not going to be anywhere close to maxing out the AFM?
     
  20. bRACKET

    bRACKET Do Right Dean

    Messages:
    3,037
    Likes Received:
    0
    Trophy Points:
    36
    Fair call, I concede haha
     

Share This Page