You need to give the flange a bit of a whack to get it to seperate from the cup thing. Then once it is loose you will be able to slide it into...
the best type of puller to use is one which allows you to screw 2 small bolts into the balancer. you can then easily remove the pully without...
No it actually snapped whilst being driven! The previous owner was driving about 60 when the engine lost power and died. I bought the Z expecting...
I've got a few mates that got their systems installed through Strathfield. Did an awesome job. Pretty good prices too. But I spose the install is...
fortunately you are not 100% correct. Pistons MAY hit the valves. I know this because when I bought my Z it had a snapped timing belt and...
broken timing belt wont stop engine from cranking unless the pistons have hit valves. pull the cam cover off and crank the engine to see if the...
Hey Mitch, Got any updates for us? I'm keen to see how it goes!
i doubt a broken heater core would stop the aircon from working!! There are likely 2 reasons for your aircon being shit. 1. Gas has leaked out...
well you'll be able to rule out the afm preventing spark. coz mine still sparks with it disconnected. got the efi engine bay fuse installed?...
Thats a nice setup you have there! But I wouldnt be surprised if you experience high speed cooling problems. The 16inch diameter hole in your...
well said buddy. my ebay hids are awesome :)
lol dude. there has been numerous tests on aftermarket water pumps and they have all been inferior quality. i can guarantee that you driving...
lol dude you are an idiot. i assume your $200 special job includes labour? And the parts are genuine? Oh wait no thats not including...
One drawback I can see with your shroud design is that it will impair airflow at high speeds. This is because all the air has to go through the...
yes
i did the dremel mod for injector no 1. made it really easy to remove it (i had alot of problems getting this injector to seat in the rail...
cant help you with the W. but the engine number is on the drivers side at the rear of the engine just above where the bellhousing is. so if you...
Absolute classic! I knew this Hectik guy was a tosser. Good work UAS.
You say that you've been in the motor industry for 15 years? Yet you have NO IDEA about how much certain jobs cost. Even If I had a stock...
Separate names with a comma.
