I have the inside edge of both front and back tyres wearing quite alot. Last time it was aligned they said it had no more camber adjustment left....
I have oil leaking down the front of the engine and down the side of power steering pump and on to the altenater. when i pulled the cam covers...
I have a stock TT auto radiator which was rodded last year $50.00 [IMG]
Drivers side targa glass is good , handle works , targa shade perfect and the bag is good. the metal has some rust . $50.00 [IMG] [IMG]...
Does any one want a bare dash the vinyl is good but some of the plastic is broken free but must be collected .No pods gauges or glovebox ect...
Stock NA manual 2+2 tail shaft prefr no postage $50
I have a manual 2+2 NA shaft for sale $60.00 prefer not to post
I have a drivers side 2+2 targa shade in good nic $30.00 and a targa bag with a small hole refer the pic$20.00 plus postage....
I am just wondering if after a manual conversion is it ok to stick in a man ecu and is there any advantage to it ,or just leave the auto one in...
the car has a bad hesitation so i have put datascan on it and when you switck off cyl 3 and 6 there is no change so i changed coil packs and...
The z back together after the man con and pp just got to bleed the clutch tonite but i could not resist trying to fire her up and she gave a...
I am just doing the wiring on my man conversion and are at the stage of wiring the clutch engagment switch so the clutch must be pressed to start...
Would anyone know which way up the plenum gasket goes ?? one side is just papaer gasket and the other has like a thin bead on the gasket...
I just wanted to check if it is ok to use the auto two piece plate that goes between the gearbox bellhouseing and the block behind the flywheel...
I have a TT auto box for sale it has done 105k and when serviced at Nissports they said the box was in good nic ,it was driving perfectly before...
I am just about to replace the rear seal and I have noticed that there is a plate held on with about five bolts that goes arounf the seal. It...
Would any one know if you can use the rear section of a tt auto tailshaft and the front of a na manual tail shaft on a manual conversion on a tt....
Does any one know if the shifter plate is the same on a US Z as our Jspec ones as they are 38 bucks in US compared to 138 bucks here ?? Cheers
I just need to know if a oem tt flywheel always has the raised section where the clutch contacts as I have one that is just dead flat and the guy...
Separate names with a comma.
