Make sure to use a quality plastic adheasion primer under your repairs and paint, on any areas with exposed plastic. Im not sure what the bumper...
Yep, so will need basecoat colour and clear. Will also need reducer/thinners and hardener.
Not a problem. Though is it a solid colour or metallic? Solid should be fine with 2l. Metalic id still say 2l colour, but you will also need...
Id say 2litres would be plenty
Good idea, shall do that!
Fixed it....somehow. Fully charged battery, checked the voltage was good, started the car, checked again and voltage went down. I couldnt really...
Haha yes, ive been meaning to update. Finding time to actually have a good look has been quite the challenge. I had a brief look during the week...
Cheers guys, ill start with the tension. Will give that a suss tonight after work, and ill go from there.
Knocking something on the alternator was my first thought, and Ill give a voltage test a try. It wouldnt be anything to do with the belt would it?...
What have I done wrong? Ive just finished replacing the drive belts with new ones, and once I started the car, the little battery light on the...
Oh ok. Ill keep that in mind. I only have to make short trips to work and back so should fine. Thanks for the heads up though
Sweet, thanks guys. Yer ive been keeping an eye on temp but its sitting fine.
Have a feeling my fan clutch is on its way out if not already. There is a very loud 'blowing' noise while driving, and when i tried spining it by...
Quick question. Are the Veilside bodykits available in plastic/polyurethane or are they strickly limited to fibreglass? Thanks in advance
I take it these are like an adjustable version of stock? What's the difference with others using the pillow ball ones?
Tension rods. What are the best to go with. Mine are flogged out, and I need new ones. I've been looking on CZP and Z1 and there is quite a...
That's one of the things I'll be checking while it's on the hoist, if it has I'm assuming I should still be able to see where the weight was glued...
Nah I havn't tried it yet, will be ordering one soon though. Thought I'd check out a few other possible causes first, planning to get it up on the...
So would I to be honest. Was going to just buy it, unless there is any negative feedback. Otherwise I'll just play the guinea pig and give it a...
Page says it's only an hour job. Shouldn't be to bad to swap over, in theory.
Separate names with a comma.
