BLAZT Cable pulled out

Took my car in for a tune and the guy hooked his hoof onto the end of my USB Blazt cable and pulled the wires out of the little circut board.

Does anyone happen to know what colours go where in the board? There are four holes and a red, black, green and white wire. I dont particularly want to try figure out using the trial and error method.

Any help is appreciated.

Cheers
Jason

 

Is there anyone out there willing to slit the heat shink cover. Pretty please???


Jason

 

Got info from BLAZT so everyone can stop worrying now!!

 

Good on you mate for

A. Sorting it out.

B. Having a friendly dig at us.:thumbup:


When I saw your second post I grabbed my Blazt cable, glanced at the
stanley knife, and thought nar, surely somebody can help this guy
without having to circumcise their cable.

 

Haha Yeah I was nearly 100% sure that I would not be the only person to have ripped one out before. Turns out the BLAZT guys were more than happy to help me out. Now I know just in case someone else wrecks their cable.

Cheers
Jason

 

Then how about putting the answer up for the next person ?

 

Haven't you read The Little Red Hen ?
No bread for us I reckon.

 

I was in the process of asking MR BLAZT if it was ok to share this information. Some people dont like it when you post information onto a forum that was intended for your eyes only.

Jason

 

BLAZT PCB Wiring Colours

 

How about adding this to the Tech Section please Mods?
It's certain to be needed again sometime(and every little bit helps).:zlove:

 

Will seek permission first

 

Inserted to tech

http://www.pexcom.com.au/z32cms/e107_plugins/content/content.php?content.615