Interested as well I'd definitely be interested in buying this bonnet too if you can make it gonzo :biggrin: I'll keep watching this thread for any updates..
This one's for you ! The hood is a VIS Racing Sports item. Here is the site link guys! http://www.visracing.com/oldcatalog/index.php?cPath=24_260
Vis is similar, but not the same. There's a lot of slightly different vented bonnets that can be found. I only found 1 ViS bonnet for the Z32 - note that the 2 side vents have raised sides, whereas the queried bonnet has side vents recessed down into the bonnet. Also, the ViS central vent has a ridge down the centre which the other one doesn't. Most designs seem to be variations on the Border bonnet, including UAS local bonnets - I'm running one of these. Double skin fibreglass, been on the car 4 years, with bonnet pins. The only issue is a couple of small cracks in the paintwork caused by the bonnet resting on T-bolt clamps, stressing it. Will be fixed when it gets transferred to the new Z. It's quite a bit heavier than the stock aluminium bonnet.
The wheels to suit the wide body kit should be easily available as they would just be a near zero offset- ie a Pre AU Falcon Fitment (don't shudder when i say falcon.) which would fill those guards nicely. However saying that, when you put a wide body kit on, do you have to literally grind the body back so that the wheel can flex up and down with out causing it to hit the body?
Yes guards will need to be cut bent up and wielded. to allow plenty of clearance for the wheels. Or the the stock guards will hit the wheels as they are out and under the stock guard by 3 inches. This Grey bonnet is available from Jun in Japan. Posted 173,000 JPY lol or $1800.00 lol still laughing Or I might try and make one. Any bonnet is easy to make its just getting the same shape of the vents the same.
