Hi all. Looking at getting new wheels and just wanted to check I'm on the right track. I want a flush fit without the need to modify the body at all or mess with camber at all. How's the following? F 18x8.5 +15 R 18X9.5 +32 Thanks
Thanks, yeah wanted a bit higher offset on the fronts but isn't available. Think it should be just ok.
Both should fit ok & allow you to run properly sized tyres. I run a 9.5" +30 square setup, both your front will sit 2mm further out & the rear will sit 2mm further in than mine. I run 275/30 rears with rolled fenders & stock (ish) camber, a 265 would probably get away without the roll, & they sit pretty flush to the rear fenders. Fronts have a little more room so yours should be fine.
How low? I'm running a couple of cm lower than lidz and have 8.5+25 with 245 tyres and 9.5+30 with 265 tyres. Fronts and rears both rolled and running -2.5 degree camber front and -1 rear. Fronts still rub on the inner liner though so your fronts are going to be the main issue. Rears may need a roll if running properly sized tyres.
Use this then measure of your existing wheels as per the results. http://www.willtheyfit.com/index.ph...eel_size=16&wheel_width=7&offset2=12#isPage=1