Hey Z brothers and sisters, a little help if anyone has experience with conZult please. I have the cable from czp and software and driver to run but upon connection I just get a dialogue box with an error message. (conZult opens but when I click on any setup buttons it spits a "computer says no" at me) hard to find info on this. any pointers appreciated cheese, Russ
got the driver for the cable... that was all i was instructed to get other than the software itself...
Try installing the latest .net framework https://www.microsoft.com/en-us/download/details.aspx?id=53344
that just looks like an offline installer....i have already installed what i need... let me simplify - conZult program active, driver installed, cable plugged but no readings from the car... error messages about
Have you tried turning it off and on again? (Seriously, lots of drivers need a restart before they work properly) Also, check the potentiometer on the ECU (little screw/dial on the side) is wound fully anti-clockwise, shouldn't take any force to move just check it's at the end of it's travel.
IT crowd? haha yeah i will try a few more avenues.... I'm obviously not doing something right. thanks guys
a couple of things spring to mind, first is the port number (depending on cable I believe) but if it uses a usb-serial adapter it needs to have the port configured, to do this you need to open devicemanger and find what port the cable is using then open settings in consult (cant remember exactly which tab this is under either - its been 4 years or so since I did this) and make sure its looking on the correct port. 2nd potential issue is the version of windows you are using, IIRC generically nothing newer than XP works without going into some sort of emulation mode or using a virtual machine (please someone tell me I am wrong and this is not the case) I still use my circa 2004 P4 celeron 2.0ghz laptop running XP so again no direct experience. Have a dig through this thread http://www.aus300zx.com/forum/showthread.php?t=324612 or this http://www.aus300zx.com/forum/showthread.php?t=326658
ok found issue. .. stupid me didnt select usb interface... so anyway upon using i noticed that im not getting readings from a heap of different sensors etc... i get tps readout which is .44 and rpm and not a lot else. could be cpu or cable problem? damn and i thought this could help solve a problem or two...not create more headaches hahaha any advice guys? somenone metioned to me today about searching for an update for the driver i am using... thought?
full version... now just had all sensors reading but a/t was not. A/T was reading on first attempt.... damn those bugs! timing was at 25 btdc so corrected that.... another thing is looks like my cooling fan isnt switching on... was told no thermostat so prob the reason for that.... anyways....
Pull the temp sensor off while the car is running and the fan should turn on if not there is a problem.