Engine rebuild cost

I thought I would throw this up for reference if anyone is searching in the future for cost of a rebuild .
This is OEM parts from CZP and machining by LW Parry Engineering in Arncliffe .
Parry have been around for a long time and I have freinds that had rebuilds done there .

This off course is machining and parts only . Freight charges not included .

Heads :
Crack and Pressure test x2 heads- $130
Head service valves/machining x2 heads- $1100
Head bolts- $75
TOTAL $1305

Block:
Hone- $110
Big end bearings- $64
Rod bearings- $32
Gasket set- $278
Ring set- $174
TOTAL $658

Optional :
Rebore- $220
OEM Piston set- $404

Forged rebuild kit- $1440

 

Head bolts- $75
Does that include the head studs too.?

Big end bearings- $64
Does that include the mains or just the big ends ? ( conrods)

 

Is that arncliff NSW?

So how much to put together roll in and out for this?

 

OEM is headbolts going straight into the block, headstuds is aftermarket ARP.

Lw Parry has been around for years and do good work have used them before.

 

Opps.. my bad.
Still learning this VG30 rebuild stuff.
Thanks.

 

Not a bad cost for a oem rebuild . Good to know for a lot thinking its time for a freshen up

 

Give them a call , helpfull pleasant people to talk too .

I just gave figures for people with a little know how and will do the rebuild themselves . So 2k sounds cheap but you will have to do a little elbow grease .

The heads also quoted on with cams and lifters removed .

There are people on this forum that have never put together an engine and have succesfully done it .

 

Big ends refering to journals of crankshaft (maybe worded wrond sorry) . Rod bearings are for conrods

 

wow thats so much cheaper than my quote..
blown vg30et big end bearing ..
they said $5k for a rebuild in lismore nsw

 

The above costs are for do it yourself with an engine that has no major damage . Just a freshen up .

If you have a spun bearing thats more work . Would probably need crank repair and new rod which is costly .

Dont forget it can cost anywhere from $500 - $1000 to pull and reinstall engine .

Then there is cost for labour to strip engine down and re assemble .

$5k is pretty good price for full rebuild (if thats what they quoted) and roll in and roll out .

 

Narh they wanted me to pull her out and strip noncritical parts ... so the wanted basicly a bare block with head attached before they would start

 

In that case if your crank and or conrod is damaged get them second hand .

Plenty of people on here have spares laying around .

And then you can do the above