Starter motor spacers

I have cut 3 starter motor spacers for people running a na manual box and using a tt flywheel and starter motor they are 3mm thick 10 bucks ea plus postage.

 

Those top feed fuel rails still on the cards?

 

they would be if i wasnt in between jobs. dont have acsess to mill and lathe anymore as the company i worked for went bust. ive got one started but cant find tome at the moment to finish them. but they are deff still on the card as there is heaps of interest in them.

 

Awesome! How about if you just run a NA Manual Box plus NA Flywheel? Is that combo compatible with a TT Engine? Are the TT flywheel's stronger than the NA flywheels? I'm going to do a Manual conversion soon more than likely, so I'm thinking ahead a bit. Can you quote me on the total cost including postage to post to 3810, Pakenham in Melbourne? I'll probably grab one, depending on answers to above questions

 

Difference is TT flywheels are larger in diameter so more surface area, not necessarily stronger.

 

a good N/A HD clutch should handle the power of a tt engine in stock form no?
what would the NA clutch be rated to, if using a say 5 puk NA clutch, could that handle 250rwkw?

 

I will take a spacer

Pm your details, Post is to 4510.

 

Nicely made matey.

Had to laugh. The last NA to TT conversion I did which used the NA box. The guy said yeah just shove a few washers under the starter

It was at that point I stopped listening to him altogether. THEN hand made an adapator just like this

 

Some people just dont get it ay. i just laser cut then took all of 2 mins

 

can supply dxf for anyone interested to get there own lasercut. just remember min charge at most places is about $50-90 bucks

 

Ill take one mate, just pm me ya details

 

pm sent

 

pm sent

 

All three sold depending on reply from big al. can make more if needed

 

I would defiantly take one if your going to make another set. PM if you do thanks.

 

yeahh chuck me down to, just incase

postage to 3137

 

Hi, I would appreciate the dxf file if you still willing...I have access to laser cutting at work. Thanks

tonytherabbit@gmail.com

 

I'll grab one if you make more

 

dxf sent

 

Thanks very much for the dxf.
Tony