WA sadly have to let her go.

hey all,

sadly after an unfortunate incident i am forced to let my Z32 go.
the car was hit by on the drivers side smashing into the front fender, door and over the rear wheel arch, with the pllar getting slightly dammaged.
i believe the cr could be repairable, however due to work commitments i dont really have the time to run around and try to get it repaired.
so the nex best thing is to see if anyone may be intersted in the car either as a project car or for parts.

the car details are:
Imported two seater, N/A, manual, the car runs prety well never really had any issues with, the gearbox was rebuild about a year or so ago, has a new exedy clutch and a single piece driveshaft. the car has a fibreglass bonnet and a veilside skirts and rear bumper, i also have a steel bonnet which i was going to use it, i also have the front veilside bumper and a set of canons which i never installed and were given to me with the car as well as having the original standard z32 wheels.

i am selling the car with everything as mentioned and asking for $800 buck for the lot. the driveshaft and clutch alone cost almost as much, i could sell the car for parts but also time restraints and other commitments dont allow me the time.

if you have any interst please let me know and grab yourself a bargain.
phoos of the car will be upladed shortly.

regards to all.

 

Still registered?

 

yes it is.

 

Cool.
Would love to see a couple more photos. Where abouts are you?

 

im in wattle grove i'll pos a few more later on today

 

Go on

Go on Brock, you know you want to sing out if you need a hand mate

 

Cheers Andy. Might be temped to dip a toe back in......

 

is it the car in your garage pics?

 

Would you let the bonnet go from the car?