APEXi SAFC-1 Bluescreen - $100 + post UAS Intake Hardpipes With APEXi Pod Filter - no vac lines - $150+ post NA Fuel Pump + brackets - $30 + post VG30DE out of my NA. - $500 210,000km Major service Done 30,000km ago Lightweight Harmonic Balancer Had good comp all around when tested Has had cylinder head work Suspected rebuild in the past but no proof. Propelled my NA to ~98MPH trap speed at the drags, this is a 14-14.3 sec engine in a slicktop, my car just never had the grip to do it. No ancillaries(alternator etc) F1 Stage 3 Clutch + Flywheel attached Perfect for someone with a blown NA wanting a bit of power too. Just a note for any lowballers out there, if i don't reply to your PM's its because i don't want to waste my time with your offer
Any chance of a stop/tail light sensor - sits at rear right next to tial assembly (in an aus spec - not sure about others) Rod - PS - fuel pump I picked up in October is alive and going well. Cheers,
I have an NA with an engine issue at the moment after overheating it. I have 135psi in all cylinders so am suspecting the piston rings so far. Am planning to remove engine, disassemble it and take the pistons out to see exactly what's going on in there. If I decide it's a write off or I somehow break it or give up on putting it back together etc. I'll be looking for an NA engine. In other words if no one want to buy this please hang on to it Cheers,
Clean up the air fuel ratio, my car was never properly tuned with it so i can't comment on power gains but SRB2NO(my cousin) gained 12rwkw with his. Also RE: the engine, it will come with receipts for the Major service($1,200) aswell. Just a fair warning, if it doesn't go by the time i'm ready to drop my new engine in, its going to cop 200HP worth of nitrous
I'd prefer you to just cop the hit to the hip pocket and blow it up with NOS, Nem. It is the responsible thing to do, since you've got a few people excited at the prospect....
Guys i also have one spare VG30DE, has UD pulley on it but is missing a lot of bits so would suit rebuild of bottom end and heads would need to be acid dipped/rebuilt due to rust. FREE to whoever comes and gets it.
Dont think the picture of the hardpipes worked. I assume the clamps and silicone hoses are included (except vacuum lines)? Would you take $100?
Does the APEXI SAFC-1 come with wiring harness? Would you take $200 delivered for the hard pipe and SAFC-1?