Helping out a friend part out his silver 2+2 which is currently stored at my place. Since I have until the end of the month off work will be pulling parts off it as requested. Loacted SE Melbourne. Will take detailed pics upon request as I don't have time to take pics of everything without buyer interest. No engine available. Front bar, headlights are now sold pending pickup. Car is a 1990 base NA which does not have ABS. Some of the more notable parts available: Full manual conversion: pedal box, clutch master + slave with UAS braided short clutch line, 5 speed trans, heavy duty Southbend single plate clutch, custom 1 piece drive shaft, transmission loom - $1500 Rebuilt R33 Brembo front calipers along with DBA 5000 2 piece rotors - $900 2k spec rear tail lights VGC - $400 will throw in the centre panel for free as it has developed cracks in it. Pair of Brembo rear rotors - $50 Near new NA series 1 EFI loom, has done maybe 5000kms - $200 has newer style series 2 injector connectors spliced on (can supply series 1 connectors with the loom or I can splice them back on for an extra $50) Full 2.5" cat back system - $200 for the whole lot: UAS resonated centre X pipe into pair of Magnaflow 14807 rear mufflers. (Willing to split but prefer not to, $100 for UAS X pipe, mufflers $150 if you buy both or $75 each) Non ABS brake master cylinder (quite rare it seems) - $75 Supervision 4300K H3 HID kit (suit Aus spec or J spec cars). This is a higher quality kit than the rubbish ebay stuff which is darker than halogens, if you search back far enough there was a aus300 group buy for these - $90 Tein Street Advance coilovers, pretty much near new and complete with brand new bump stops and top mounts, bolts straight in - $500 Most stock parts available, interior trims, stock suspension arms, NA subframe, NA power steering res and pump, starter motor, all electrical connectors - happy to post/courier items at buyer expense.