VIC Banjo fitting from small power steering hose

Discussion in 'Wanted' started by ivan129, Jul 8, 2018.

  1. ivan129

    ivan129 Member

    Messages:
    221
    Likes Received:
    3
    Trophy Points:
    18
    Location:
    Are we there yet?
    Hi, I'm after one, (two if I can get them) of the small solder banjo fittings used on a Z32 power steering rack. These the smaller 1/4" pipes that fit to the top of the rack. The part the bolt goes through is the banjo fitting I'm after. Hoping someone out there might have some. The only ones I can buy are for 5/16" bundy pipe.
    Thanks. Location, Cranbourne. Vic Ivan. 0417399954
     
  2. TWIN TERROR

    TWIN TERROR Active Member

    Messages:
    2,247
    Likes Received:
    22
    Trophy Points:
    38
    Perhaps try one of the hydraulic hose guys. They carry a crap load of different fittings at the bigger one like Enzed and if they don't have them they would more than likely know where to get them.
     
  3. ivan129

    ivan129 Member

    Messages:
    221
    Likes Received:
    3
    Trophy Points:
    18
    Location:
    Are we there yet?
    Yea tried Enzed, Nordens and hose doctor. The ones used on the zeds must be hens teeth.
     
  4. lidz

    lidz Well-Known Member

    Messages:
    2,126
    Likes Received:
    31
    Trophy Points:
    48
    Member Kr4usy (Andrew) is wrecking a zed in Melbourne, maybe see if he can help you out?
     
  5. Martin Williams

    Martin Williams Active Member

    Messages:
    1,359
    Likes Received:
    11
    Trophy Points:
    38
    I have a couple of steering racks with the pipes/banjo fittings but it would mean robbing a perfectly good steering rack. Guess you must have damaged one taking out or putting engine.
     

Share This Page