For Sale Z32 spares

Discussion in 'Car Parts for Sale or Wanted' started by MikeZ32, Dec 9, 2021.

  1. MikeZ32

    MikeZ32 das Über member

    Hi all, cleaning garage and found some stuff that are still perfectly usable.

    2k spec MT shift knob w/ red stitching $80
    standard MT shift knob without leather just rubber $40
    [​IMG]
    [​IMG]

    2+2 targa top trim pieces WITH plastic end cap (Left side only I think but can confirm)
    and locking plastic cover and I do have the caps as well. (No mechanism, this is the full set of trims only for lockable 2+2 targas). Prefer not to separate: $100

    [​IMG]

    Working hazard switch and button: $25
    Water pump pulley: $10
    Driver door trim piece: $10
    Stock intercooler mounts never used: $80 for the pair or $40 ea.
    Seatbelt trim covers: $5 ea have 4 available
    T25 to T28 turbo inlet converter for factory bolt on inlets. Bolts onto Z32 specific GT28 turbos so you can still bolt on the stock metal inlet pipes. $20 for the pair.
    New PCV hose - tapered piece which cannot be replaced using generic part.
    Nissan Part#11826-30p10: $15 - you can find the diagram here:
    https://www.nissanpartsdeal.com/parts/nissan-hose-evapo-cont~11826-30p10.html

    [​IMG]

    And below self explanatory stuff which I haven't taken photos of but can provide if you need to see them:

    Throttle pedal - $20
    Throttle cable - $20
    TT oil filter tree - $50
    Engine IACV and AC valve (the 2 air control solenoids that sit at the back of the plenum and control idle) - $50
    Brand new knock sensor bypass resistor with factory plug (temporary fix to get the car working again until replaced of course) - $20
    Brand new Ryco Z202 fuel filter - $20
    Good condition factory NA fuel pump with fuel sock - $50
     
  2. MikeZ32

    MikeZ32 das Über member

    just an update on this, still have quite a few parts:

    2k spec MT shift knob w/ red stitching $80
    standard MT shift knob without leather just rubber $40
    2+2 targa top trim pieces WITH plastic end cap (Left side only I think but can confirm)
    and plastic cover and I do have the caps as well2 +2 targas). : $100

    [​IMG]

    Working hazard switch and button: $20
    Water pump pulley: $10
    Driver door trim piece: $10
    Boot release: $10
    Stock intercooler mounts never used:$40 for pair.
    Seatbelt trim covers: $5 ea
    T25 to T28 turbo inlet converter for factory bolt on inlets. Bolts onto Z32 specific GT28 turbos so you can still bolt on the stock metal inlet pipes. $20 for the pair.
    New PCV hose - tapered piece which cannot be replaced using generic part. Nissan Part#11826-30p10: $15
    Throttle pedal - $20
    Throttle cable - $20
    TT oil filter tree - $50
    Brand new knock sensor bypass resistor with factory plug - $20
    Brand new fuel pump cradle O ring - $15
    Good condition factory NA fuel pump with fuel sock - $40
     
  3. MORBOOST

    MORBOOST Active Member

    where you at? pm if you dont want it public
     
  4. MikeZ32

    MikeZ32 das Über member

    pickup braeside VIC

    few more bits are sold. updated list below:

    2k spec MT shift knob w/ red stitching $80
    standard MT shift knob without leather just rubber $40
    2+2 targa top trim pieces and plastic cover for 2 +2 targas : $50
    Working hazard switch and button: $20
    Water pump pulley: $10
    Driver door trim piece: $10
    Boot release: $10
    Stock intercooler mounts never used:$20 for pair.
    Seatbelt trim covers: $5 ea
    Throttle pedal - $20
    Throttle cable - $20
    TT oil filter tree - $50
    Brand new knock sensor bypass resistor with factory plug - $20
    Brand new fuel pump cradle O ring - $15
    Good condition factory NA fuel pump with fuel sock - $40
     
  5. liability56

    liability56 New Member

    Do the targa trims come with those flat square plastic buttons that you need to push in so you can open the lever?
     

Share This Page