Syd: Lathe for 18" rims

Discussion in 'Non Technical' started by Shane001, Mar 6, 2017.

  1. Shane001

    Shane001 Well-Known Member

    Anyone got access to a lathe that could mount an 18" rim in Sydney?

    I have a set of rims that I need to have the centrebore machined out to 66.1, currently it's around 60mm (Supra spec).
  2. zx299

    zx299 Well-Known Member

    You might get that job done with a boring bar ......

    get in touch with an engine builder and see what they can do
  3. AndyMac

    AndyMac Better than you

    Or anyone of the wheel refurb workshops in Sydney.
  4. Fists

    Fists Well-Known Member

    Barrel bros are in sydney are't they? Would assume they're the go-to shop for that sort of thing.
  5. Shane001

    Shane001 Well-Known Member

    Anyone got any experience with, recommend any wheel refurb shops?

    Will look up Barrel Bros and see if they're local.

    QLDZDR ID=David


    This pic is on


    Borehole or hub machining
    Offset machining
  7. Wizard

    Wizard Kerb side Prophet

    Magman at riverwood
  8. Anti

    Anti 14.7 x 14.7 = 44.1

    Magman has been good to me, or Tempe Tyres IIRC
  9. Shane001

    Shane001 Well-Known Member

    Thanks guys, need to get onto it this week.

    Bathurst is fast approaching :br:

Share This Page