Z32 Replacing Brakebooster

Discussion in 'Technical' started by losertwo, May 7, 2020.

  1. losertwo

    losertwo New Member

    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    1
    So i'm currently replacing my brakebooster, I've taken all the nuts off where the brakebooster is bolted down inside the car near the brake pedal. my question is how do i remove the pin that connects both brakebooster to brake pedal, it wont come out i've taken the clip out already but there seems to be a plastic end on the clevis pin which stops the pin from coming out. photo below for reference plastic end. cheers
     

    Attached Files:

  2. rob260

    rob260 Moderator Staff Member

    Messages:
    13,190
    Likes Received:
    255
    Trophy Points:
    83
    Location:
    Sydney (North)
    Gotta remove the plastic piece. Needle nose pliers come in handy in that location.
     
    Last edited: May 7, 2020
  3. losertwo

    losertwo New Member

    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    1
    Thanks a heap rob!
     

Share This Page