Z31 Removal of FICD on a 1985 build

Discussion in 'Non Technical' started by Coopz, Jan 1, 2021.

  1. Coopz

    Coopz New Member

    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    1
    Hi All having trouble with FICD following FSM procedure it makes no difference to idle up or down. If I removed it and blanked it off would it make any difference to engine idle Etc. At the moment the engine starts and idles then bogs down and stops. It makes it difficult to check fault codes or can you do it without engine running thanks Coopz
     
  2. NI85

    NI85 Active Member

    Messages:
    137
    Likes Received:
    25
    Trophy Points:
    28
    Location:
    Sydney
    Check the air regulator to see if it's stuck closed as it affects idle till the car warms up

    Is the car turbo or non turbo?

    Unplugging the connectors would have the same effect as removing it.

    The car doesn't have to be running to check codes, just ON
     
  3. Coopz

    Coopz New Member

    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    1



    Yep thanks for that will check air reg think I will remove FICD makes it easier to get at the plugs as well. Not sure air reg works but I have FSM thanks.
     

Share This Page