Heater core

Discussion in 'Technical' started by 8300zx9, Oct 6, 2012.

  1. 8300zx9

    8300zx9 Active Member

    Hey y'all.... Now just fitted up my new core with dash in,.. It very easy this way! But I have one 3mm x 30mm or so fine thread screw left over lol.... Probably a long shot, but has anyone done this job and know where it goes?
  2. ezzupturbo

    ezzupturbo JDMAutomotive

    it will be for you heater tap
    the nut will still be in the plastic
  3. 8300zx9

    8300zx9 Active Member

    Hmmm, I didn't remove the tap :/ well I did but just off the core it's self. Just the 4 small screws, I left the cable on also... Would it be just for holding the control unit on maybe? One up higher out of sight?
  4. tassuperkart

    tassuperkart Its a lie I tell you!

    Im guessing its the screw that secures the metal pipes where they exit the firewall.

  5. 8300zx9

    8300zx9 Active Member

    Yeah not sure lol... It works and no leaks, so guess the screw was just over engineering.... And just imagine the weight saving! :p
  6. TQE-756

    TQE-756 Active Member

    Left Shoulder, mate!

    Stand somewhere appropriate and throw it over your left shoulder... don't throw it over your right because then it will become instantly apparent that it was needed somewhere :p
  7. 8300zx9

    8300zx9 Active Member

    ^^^^hahaha done ;) is it just me or every job I do I have left overs ;p lmao
  8. CHILI

    CHILI Indestructable Target

    If you had bothered to save those extra bits, one day you could have built an extra car. Silly Boy!!!:p:rolleyes::br:
  9. 8300zx9

    8300zx9 Active Member

    Hahaha yeah it's my plans Chili ;)

Share This Page