Changing Auxillary Fan NA to TT

Discussion in 'Technical' started by jaybo, Jan 27, 2011.

  1. jaybo

    jaybo New Member

    hi,
    Did the TT conversion a while ago, and recently picked up through a bit of reading that the NA and TT auxillary fans are different. NA is one speed, TT is two speed.
    If i wanted to change to the TT one, then do the mod so it comes on at different settings is this a simple plug and play mod?

    Otherwise would i just be better off rigging up the NA auxillary fan to come on when the ignition comes on?
    cheers
    Jay
     
  2. WazTTed

    WazTTed Grease Monkey

    tt has 2 speeds, na is a one speed. just run your na fan on a switch full power. the tt low power setting is a waste of time.. are you having overheating dramas???

    you can setup a manual switch for the aux fan on a relay if you want
     
  3. jaybo

    jaybo New Member

    on really hot days the temp is getting up there, so i won't bother driving it on those days. also idling in traffic it cuts out sometimes so i'm just going through everything to give it the best chance.

    is there a tech for putting the NA fan on a switch? or can i just have it connected to the ignition so it runs that way all the time?

    i've got a FMIC which i don't think is helping airflow either but then i've got a vented nose panel and a vented bonnet which i thought would help.
     
  4. WazTTed

    WazTTed Grease Monkey

    are you running a clutch fan??? udp ??? by anychance. could be a faulty clutch fan.. if your aux fan is cutting on and off id look at the cts sensor dude... the aux fan shouldnt be coming on unless your at 109 degrees !!
     
  5. Kabir

    Kabir Well-Known Member

    You can add extra relay so that whenever AC comes ON fan will start at full speed which I did. However this fan can only drop 2/3 degrees which is not much. I would consider a new clutch for the fan. Temperature will drop at least 7/10 degree.

     
  6. jaybo

    jaybo New Member

    I'm running an UDP. Probably need a new clutch fan as i don't think i replaced it when i did the TT conversion.
     
  7. WazTTed

    WazTTed Grease Monkey

    u need a water pulley over drive pulley then.. probably a clutch fan aswell
     
  8. jaybo

    jaybo New Member

    Sorry also got a water pulley.

    I reckon clutch fan will be best way to go.
     
  9. WazTTed

    WazTTed Grease Monkey

    got your front undertray plastic guides on aswell?
     
  10. Vader

    Vader Just another guy

    If the NA and TT fans both run at the same speed (at full speed), what use is there adding the slow speed setting to the NA fan? I suppose the only difference would be the NA would potentially run hotter than the TT until it reached the fan start temperature.

    Following that line of (un)logic one would think the TT fan must run faster than the NA fan.

    Can anyone confirm?

    PS +1 for the clutch fan.
     
  11. Jinxed

    Jinxed Moderator

    jay, i have a tt aux fan here you can have cheap cheap if you need one......
     
  12. jaybo

    jaybo New Member

    Hey Ross,

    I've got a couple of spare aux fans in the roof space which all seem to work still. I reckon the clutch will be the way to go.

    I've got the underguard plastics on definitely - wouldn't risk driving without them.

    I think the days its got hot have just been very warm days and i've been idling in traffic.
     
  13. WazTTed

    WazTTed Grease Monkey

    yeh id say clutch fan on the way out or your belt is really loose !!.. you are running a fan shroud correct?
     
  14. jaybo

    jaybo New Member

    Belts are sweet and tight, shroud fan is in.

    what's considered normal engine temp for a TT?
     
  15. WazTTed

    WazTTed Grease Monkey

    idle to normal driving 80 to 90. bit more with your ac on
     
  16. jaybo

    jaybo New Member

    Cool, that's where i'm sitting at. Mostly around 78 deg at times.
     

Share This Page