300zx widebody kit by diamond autocraft

Discussion in 'Non Technical' started by TigerZ, Nov 26, 2009.

  1. TigerZ

    TigerZ New Member

    Thoughts on this?? (Not sure if this is a re-post)


  2. muffler

    muffler New Member

    that look shit
  3. directzx

    directzx New Member

    looks sh*t

    why cant someone just make a nice, simple widebody kit that takes the original lines of the z32 and exaggerates them just a little bit?

    something that will look good riveted on, Not glassed.. Please ??

    URHYNS Well-Known Member

    Thanks for sharing, again.
  5. psycodelik

    psycodelik psyco led's

    ummmmm..... [TIS][TIS][TIS]
  6. yellow300zx

    yellow300zx Pimpin Ain't Easy

    Gonzo's was pretty nice.
  7. Steven

    Steven Active Member

    Too Busy

    Too Busy...

    Too many side lines ... I would get rid of the air intake which faces forward in from of the rear wheel arch. But I will say that the rear does change the rear shape to make the car look something other than a 300zx. I could see the car in a metallic orange or a deep candy-apple-red.

    The front nose looks too big ... it needs to be broken up with a pair of standard indicator lights and square driving lights.

    Ummm, how do I unlock the boot?
    I would scope the outer ends of the rear diffuser to match up with the inner edge of the side taillights.

    Front bar, side panel, and centre panel as one piece is STUPID from a logistical point of maintenance and repair. "oh, wait I have to remove the whole front end to clean the air-intake pod-filter, and god I hate driving in autumn the leaves get stuck in the nose". ... should be three distinctive pieces.
  8. ed300zx

    ed300zx Active Member

    i like it. not as a modded 300zx but just as a car in general
  9. Kieren

    Kieren Active Member

    They've just made a new car.... where's the 300ZX?????
  10. ed300zx

    ed300zx Active Member

    exactly....and thats what i mean by my comment, i like it as a car (as in a new car) but not as a modded 300zx (because there isnt much stock zed left(body shape wise))
  11. Chrispy

    Chrispy Pretentious Upstart

    I like it better than the Strosek kit. It's not too bad I reckon. Really digging the back.

    Can't take any styling advice from you Steven, you have Ferrari lights :p
    MagicMike likes this.
  12. cherryZ

    cherryZ Truth Addict

    Arse end looks like a modern interpretation of the Porsche 928. I think it could look pretty tough... but definitely no point calling it a Z.
  13. MagicMike

    MagicMike Moderator Staff Member


    I don't mind the rear bar section, rest is ok. Not worth the drama to fit tho...
  14. THEZED

    THEZED Loose Screws Inside

    I think the front looks agreeable and the rear as well. However the side is too angular. It looks too square/boxy. However as some as said, it looks like a entirely different car, not the 300zx. Maybe the future of the 300zx now renamed 300z (as opposed to the 350z and 370z) in an alternate universe........ :p
  15. JD-3193

    JD-3193 New Member

    I actually think I like it! I'd have to see it sprayed with the indicators in though.
    I'm imagining it in bayside blue... :zlove:
  16. jaybo

    jaybo New Member

  17. Benny_C

    Benny_C About as subtle as...

    I actually like it! putting aside the fact that it completely changes the shape of a stock Zed, it still looks like a very agressive body kit! i'd have one! :eek:
  18. JD-3193

    JD-3193 New Member

    ...Do it :D
  19. dannY_trev

    dannY_trev New Member

    i like it too, would be interesting to see what happens with the rear lights but i think the zx rear is beginning to look dated.. would look great with a diffuser of some sort, and maybe a bigger opening on the front bar
  20. JD-3193

    JD-3193 New Member

    The indicator slots at the back look kinda similar to a 350Z.


Share This Page