Hi, Has anyone replaced their injector drivers? I assume from sources around that the below two chips do this function, one for each side of...
[IMG] The hose with the crack in it, where does it go? I assume its the turbo coolant return line? If so where could I relocate it to since...
Anyone know what size the hoses attached to the iac etc. are?
Hi all, Having some problems with my z missing, it runs rough when cold however it will continue to miss when warm but not as bad. (misses every...
Hi all, just found out that one of my nismo injectors has failed and cannot be repaired :'(. Is there anywhere in aus that I can just get one...
Anyone on the southside have a consult cable that I can borrow tomorrow?
Hey can anyone tell me the pinout for the cas plug? I must've written mine down wrong =/
Anyone found 30mm hose that has a decent angle to use on aftermarket bovs to recirc them? It is turning out to be extremely hard to find =/
I have an odd issue with my alignment, I finally installed some front camber arms as the camber was out by a full degree on the right side, now...
Anyone know where I can get some decent brake ducting in brisbane? This kind of stuff but in 60mm
I have a problem with an AEM Boost gauge, I need an IGN source that does not cut out when you crank the engine. Anyone know what source I...
I have a spare Manual 2+2 TT Tailshaft, will need a new uni - was quoted $40 from Hardyspicer to replace the uni, however I doubt that includes...
Anyone ordering some parts from conceptzperfromance? I'm after a set of stillen upper control arms but the shipping will be way too expensive for...
Does anyone know where this hose goes to? I assume it goes down towards the fender somewhere, anyone have any pictures of where the hose ends up?
Off my old TT frame as I installed a na rearend Rear hubs - $20 http://imageshack.us/photo/my-images/225/photoa4270677b13183dc0f.jpg Hicas...
Does anyone know if the metal case inside the diff bushing on the rear subframe is interchangeable between na and tt?
Can anyone tell me how long the NA tailshaft on a 2+2 manual is? Searched around and can't seem to get a figure.
Just in the middle of installing my NA Ps pump, The na pulley is 3 ribbed and the tt is 4, read a few threads saying you can just chuck the tt...
Anyone know the size of the NA j-hose? (the hose that goes from the pump to the rez)
Does anyone know if the tailshafts are different between 2+2 and 2+0? The manual seems to state that there is only a difference between at/mt and...
Separate names with a comma.