Hi Guys Have one of the V1 turbotech MBC in the garage, wondering if anyone has used or is using one. I don't want to or need to run various...
Hi Guys Quick question planning to finally get my car tuned in the next month or so I have a spare rail which I was going to have AN ends...
Hi Guys Finally putting up my n/a motor for sale which came out of my 92 Aus-spec zed for the TT swap. Few details on the motor. -Came out...
Hey guys I'm tossing up between a selin twin intake or adjustable exhaust cam gears. Just seeking advise on which mod to do to increase...
Hey guys Replacing the cam seals, do the new ones go on dry or oiled? Oiled will go on easier but do either methods affect the sealing of the...
Hey guys Just pulled the timing belt off and left intake cam gear to replace a leaking seal. Though the gear itself has a lip in it which is...
Hey Guys Looking at getting a Sard, Turbosmart 800 or Tomei Type L fuel pressure regulator for the zed. Plan is to have OEM rail modified...
Hey guys I have just noticed on ECU talk that my TPS voltage on idle will be anywhere from 0.4 to 0.5 and when driving it will flick around for...
Hey Guys I have adjustable wastegate actuators on my Z1 GT2860R kit, thing is I'm not sure when they will start to open. I don't want a minimum...
Hey guys Can I fit these to my engine whilst its out, more so in regards to the driver's side with the steering column? Have AMS manifolds,...
Hey guys How long should it take to get oil pressure on a brand new TT motor? Have done 4 intervals of 30 seconds to get oil pressure yet the...
Hey guys Does the steel plate/sheild about 1mm thick that sits between the box and engine - MUST it be there or not necessary??? Only reason...
Hey guys The crank I used in my engine which has recently been rebuilt came from an auto. How do I go about removing the spacer which sits at...
Hey Guys Have ARP headstud and I have just noticed they are much smaller in diameter compared to the OEM washers. Are they fine to use? Also...
Hey guys As far as I know all exhaust cams are exactly the same for all series 1 zeds. With the only variance on auto TT intake cams with less...
Hey Guys The locating/drive pin for the CAS has broken off and gone missing from my passenger side exhaust cam. Who else has had this happen to...
Hey guys few questions I need to find out on.... 1. Just spoke to the guys building my bottom end and informed that 6thou / 0.006" had to be...
Hey guys Getting a forged bottom end build Wiseco 87.5mm pistons and Eagle rods. Now what are ideal piston to bore clearances? Wisecos come...
Planning to get one of these for the zed, from what I understand FPCU needs to be bypassed so it has constant power. Also would the pump...
Hi Guys New OEM headbolts is there a certain limit of power/boost before they give way. I know of RB motors and 2JZ's running bigger turbos...
Separate names with a comma.