Thanks dude. I reckon I have nearly got the hang of it now.
This time. Sideskirts $100.00 [IMG]"][IMG][/URL] [IMG][/URL][/IMG] [IMG][/URL][/IMG] Custom fiberglass 12 inch sub woofer boses...
Sold the z a while ago, time for the clean out of left over bits and pieces. I have a pair of fiberglass side skirts for a two seater. I got...
Dude, I have never heard of that one before. Thanks for pointing it out.
Play around with the wiring connectors while the engine in running. A quick blast with wd40 cleans up the contacts in the connectors if that is...
I was actually thinking about taking the aftermarket rims off the z I am selling and putting them on a ba pursuit ute. I have a really nice set of...
Easy question I spose, with a simple answer. I am curious to know if ba rims will fit on a Nissan. I'm pretty sure the stud pattern is the same,...
Anyone recommend where I can find a rear main seal for a z with a twin turbo and a five speed manual? I was selling it but now I am coming...
If it is the heater core you can bypass it, so you don't need to pull the whole dash out to fix it. There should be an article on it in the tech...
Time has come to sell my z. Sad to see it go, I still like driving it around. I was having trouble with it breaking down and it turned out...
I had problems that were similar for a while including the car stalling after I hit a bump. It turned out that I needed to replace the positive...
LOL. That's unfortunate. So how long is the long bolt and how long is the short bolt? The one I am talking about I can put a socket on from the...
Dude, I will have a look. So far I have only been able to find one bolt. There is a bit of a space there that a nut and washer might just slot...
Thanks for the advice guys. I guess it will be done properly. I will check with the guys doing the rwc and see if they do it too.
It came up during a rwc. The starter motor is loose. I found one bolt so far and tried tightening it up and it must be threaded inside because it...
I bought a new cas when I was having car trouble and it turned out to be the positive battery clamp needed repalacing. It has done about 40 k's. I...
I disconnected the cas and tried to turn the engine over. It turned over okay so I figured it is not the cas. It turns out that the battery...
thanks guys. I was getting frustrated. I noticed that the battery cable connectors look a bit like they need replacing. i will give it a go tonight.
dude, its brand new.
I tried disconnecting the cas plug and you were right. The engine still turns over. It is not the cas. Where are the main fusable links?
Separate names with a comma.