Ok so basically i did a full rebuild a bit over a year ago due to piston number 6 having its side blown out! I now have lost compression on...
As some might know I rebuilt my engine about a year ago but I have already done the rings on cylinder 6. I have read somewhere that some metal...
Hi All, Well the car was running fine last night, then she struggled to start this morning and limped down the road. i decided to then leave it...
So this is really for anyone in Tassie after this bar, as it will save you the cost of shipping. I am having an insurance job done on my Zed...
Hi all, Just replaced a couple of my remaining old injector connectors after a plenum pull and i have a non-firing cylinder :( I have some...
I've done a plenum pull... already! because of a vacum leak. Now i'm considering doing the under plenum coolant hose bypass. HOWEVER i'm not sure...
Hi all just wondering what i might have connected up wrong to do this... Put a new head unit in and now when i turn the headlights on the...
Hi All, I took the Z for a short test drive out the driveway tonight (couple hundred meters up the road). She was running smooth, all good....
Holly crap! I had the biggest lump in my throat when i went to turn that ignition key! After 2 years off the road and months worth of pain...
Hi all just a quick question. I got my S2 PTU in the post tonight so about to put it in. Was wondering if there are some specific wires in the...
Hi all, did a search on this and found a nice one for the 2 seater but this won't really work for the 4 seater. I was wondering if anyone has a...
Hi All, finished all the final electrical and vacuum connections last night and tried to start the car today. She's cranking but not starting...
Hi Just wondering if anyone has a collection of pictures somewhere online of the exterior of a whole TT engine so that i can refer to these to...
Hi all just wanted to make sure that this is ok... I've got an Unorthodox Racing underdrive pulley and the timing mark does not line up with...
Hi All, just wondering if there is any reason why i shouldn't drill extra holes through the head gasket where some of the coolant galleries are...
OK everyone, the time has come for me to sell up . I didn?t imagine the day would come but it?s the best thing for me to do right now as I?m...
This is going to sound like a really stupid question but i just want to 100% sure... when i got my pistons etc back from the machining workshop...
Hi all, I havent been able to find much in the search section. I have been trying to install the cir-clips into my ACL pistons but havent...
Hi All! Ok, brief background: Towards the end of November 2007 i was racing my Z at Symmons plains for a club sprint day. It was a warm 27...
Hi All, I'm at the point of removing the crank shaft from myengine block and have come to a stopper. I have removed all the bolts that i can...
Separate names with a comma.