I have been doing some searching and kind of confused on which way the adjustable front upper control arms are sopose to go. Was reading a couple...
I have an FMIC which is from the very first group buy. The FMIC comes with everything that come in the group buy. It has not been used at all just...
Ok i have a front mount intercooler for sale from the very first group buy James had... It comes with everything... Looking for $550 for the...
Hey guys and girls i am after the part number for the wiring harness for the S2 PTU if anyone knows it...
Just wanted to know if anyone uses the Amsoil oil filters at all?? Got some amsoil oil and oil filter today and most likey going to do an oil...
I am after the part numbers for the S2 PTU connectors if anyone knows them. Nath
I have a complete FMIC from the very first GB James had. It has never been used just sitting here in the box doing nothing. It has not even been...
I just replaced the 2 fuel lines and have installed a fuel pressure gauge into the line that runs to the fuel filter... The gauge is for an efi...
Ok i have been going though the tech only one in which works is of minivan's one... I have been going though JT's thread about it all as well and...
When i am in park and at op temp my idle seems to be the same as what it is when i have it in drive... I adjusted my TPS the other day to .44...
I am looking for a good firewall to use... I am using AOL Active Virus Shield powered by Kaspersky... I was using amshampoo firewall but for some...
I would like to thank the person that is going around bad mouthing my detailing work. I would appreciate it if they were man enough to step up and...
Ok well i had a service done on my auto... I was reading the tech about using the one out of the petrol... Anyways was going though the powermax...
I have a set of brand new RDA front slotted TT rotors sitting here... I am after $170 for them... Melbourne only! Nath
Well if any of you went last night you might understand what happened.. I have been reading about what has happened... I suggest anyone on this...
I am after the following part numbers.. I dont have that nissan program to check and to me it looks hell confusing then using holdens system......
Ok i have done alot of research as well as doing it myself over the years... I have been a fulltime car detailer for over 3 years now but started...
who has a black zed with the plates 10ACE?
Ok so i plugged in the laptop and ran datascan still using v1.4... Well come up with code34 2 starts ago.. So i am like hmmm so i reset the ecu...
Well as it stands I can get some deals on RDA rotors, Brake pads and exedy clutches... I can only do the rotors and clutches to melbourne based...
Separate names with a comma.