Hi all I have a 1985 model and the globe in the overdrive on off switch in centre consul needs replacing.They are a tiny little buggar with two...
Wanted speedo assembly for Z31 1985 or more specifically fuel gauge and Temp gauge
Replaced water temp sensor and reconnected as soon as I started [a cold engine]the coolant fan came on when I took off wire to water temp sensor...
Many thanks for info.
Can someone tell me what the Ohm range is for a Water temp sensor on a Z31 1985.I have a couple think they are to low Thanks
Hi can you help me with a water temp sensor which needs replacing. The thread appears to be close to a gas type thread the one tridon supplied has...
OK I have a Z32 air reg have taken it apart [it fits a ZX31 opening]and will fit a generic choke cable back to under dash. I will take a few pics...
Yep I thought that would be a possibility. thanks. I'll see if I can take it apart and have a look inside
Hi having trouble with fast idle when engine is cold, I bought another so called working regulator off a wreck tha'ts cactus as well . Does a...
I have 2 pairs of front guards with some rust at the bottom of fender, they are still very usable and some have rubber guard surrounds they are...
Hi All my spare tyre needs replacing having trouble finding one a Bridgestone 165x15 Fold flex does anyone know where I can get one or similar in...
Thanks for info very useful, however I managed to find the culprit. The plug on loom from CAS although clipped together ok the connection seemed...
I only replaced CAS the car ran prior to replacement but was hard to start like it wasn't getting the fuel, it has new fuel filter and the fuel...
Sorry I meant I cleaned Maf sensor before installing CAS and Head sensor
Ok have taken off MAF sensor and spray cleaned it didn't look to dirty to me I didn't check continuity though car did run after that it was after...
I have replaced Crank Angle Sensor as so many due to a lot of error codes I have also replaced Cylinder head sensor checked vacuums and replaced...
Yes algood in that department.
Hi All can you give me a heads up on a scanner for Z31 I'm not looking for an expensive one but one that is reasonbly priced maybe $100 or there...
Separate names with a comma.