Odd one that I know is documented but I can't seem to find the fix link. TT speedo bangs over to 180km/hr on startup and then proceeds to run...
Not my car, bumped into the guy at the servo while test driving my black 2+2. But can attest to it being a super clean, super stock well cared for...
Hi all, Was slotting pistons and rods back into an engine I'm building at the moment and pinched an oil control retainer ring (the thin little...
Finalizing the stocker build for the wifes 2+2, don't really want to spend $500 on ARP's when the car isn't going to be a dyno/track monster. Also...
I hate all the shit that hangs off the side of these motors in terms of vacuum lines and boost control associated noise. Can I turf everything...
As I'm now chasing a set of rods for the black 2+2 TT, I've got a couple of questions. Is there any difference between the stock NA and TT...
Anyone know what this is? Throwing around some ideas around a really wild Z32 based project the likes of which has never been done, wheelset is...
Once the black 2+2 manual is on the road for my wife I'll be cracking on with the blue 2 seater. The plan for this is to be properly fast...
It's no secret that underbonnet heat is a major killer of Z32s roasting pipes, lines, radiators etc. Will have at least one z32 back on the...
As mentioned in my rebuild thread the oil filter tree gasket has failed just after the motor went back in the car. I really REALLY don't want to...
The motor for the wife's Z32 is almost complete and ready for reinstallation but noticed that while the exhaust cam rocker cover comes with a nice...
Currently trying to fit up a new rear main seal before the drivetrain goes back in the 2+2 and for the life of me I cant get the seal to go back...
Rather than spend hours trawling through heresay can anyone tell me what the widest wheels that can fit under a Z32 without massive guard mods?...
Looking for a set of head studs for both zeds I have at the moment and the ARP 202-4308 is about the only one I can find but its not cheap...
Looks like mine are flogged, where is the best place to grab them? Are they a part used with other models that can be purchased cheaply or are...
Hi all, After a long period of being tied up with other stuff I'm back screwing our pair of z32's together. Have just done the plenum pull and...
I intend to turf them when the engine goes back in as I much prefer a bit flutter however it seems like most Z32 builds I see retain them or have...
Have removed the EGR setup from the project car before the motor goes back in, does removing it trigger any fault codes with the factory S1 ECU...
I know most members of the forum will scoff at this kit, and I'm also aware you get what you pay for but has anyone actually used this kit or...
Hi gents, Time to shift the parts car out of the driveway. It's a red 89 TT manual 2+2 as per title that was collected by a drunk driver a few...
Separate names with a comma.