324mm Drilled and Slotted front rotors, adapters and front Calipers, rear slotted rotor and calipers, these were rebuilt & bought from forum...
Hi All Need some help deciding wheel size for Akebono 14" 350z brakes, Currently looking at some Miro 111. Size options are 18" x 8.5 with 35...
Hi All So the engine was run in on the Dyno and the oil was replaced after the Dyno tuning with a cheaper quality fully synthetic oil, have done...
can some one confirm if the Z350 front Calipers are the same as the R34 GTR BNR34 Brembo Front Brake Calipers. And if so are they a direct bolt...
So got the new engine in, heads were done by Blackwell race engines, has new supertech .5mm oversized valves with duel valve springs, so it is...
OK currently finishing off my Forged Motor Build! Now back in the old days before Synthetic Oils, we use to put cheap oil in for the first...
Just wondering if I need to remove these bungs to clean out the oil galleries before reassembly, and if so what else should be done to them? As...
Thought I would start a new thread continuing on from the Top feed under Plenum fuel system. For those of you who have been following here is...
Up for sale is a genuine Nissan MAF with good screens, Only selling as I am running MAP on my zed. $80 plus postage.
So was planning to make my own top feed fuel system, so having a spare lower & upper plenum I made a start with some standard top feed Injectors I...
I have up for Sale my Nistune ECU comes with Licence It will come with either Stock Manual or Auto Tune just let me know and I will load the bin...
Basically idles like a dream but if I give it a rev it will stall on rev down, I have checked MAF all OK, Checked IACV / AAC and works fine, I...
So one of my stock injectors decided to die and it just happened that I had a set of 600cc injectors lying around that I bought from forum member...
I have a Set of 600CC JECS Injectors in fuel rails, I bought these from forum member Pennyarvs / Arvin about 9 months ago and never installed...
Had aircon fixed when I first got the car cost me $550 to install a Relay. Changed out Engine and ECU and now the Aircon compressor won't engage...
Trying to get the new engine running properly but has a big hesitation from idle before revving and sometimes will stall after revving, and when...
I have done the AIV & EGR delete since the engine was out, but need help with what happens at the motor side since there are around 4 hoses that...
Need to get some extra wires for the VPC & EVC thru the Fire Wall so I thought I would post. Hope this is helpful to someone. Removed the...
When fitting up the new AMS 2.5" piping Kit noticed the Silicon Reducer Hose was a sloppy fit to the Turbo Outlet Housing Passenger Side and when...
Just wondering will the standard tune run ok to drive with 600CC injectors installed or can I update to a more compatible tune that will get me...
Separate names with a comma.